Apparently in frustration with the progress from Rossi, a private Swedish investors group sent a technician to monitor the testing of the new, high temp. reactor at Rossi\u2019s Bologna facility. The INPUT power measured by the technician were 2 to 3 times higher than those mentioned in a report by the Rossi engineers. So, the \u2018technician\u2019 prepared a PRESS RELEASE that told the world about this discrepancy! The Swedish group promptly halted their involvement with Rossi.<\/p>\n
If INPUT power is 2 to 3 times higher than Rossi is reporting \u2018on all his reactors\u2019, the calculated over-unity OUTPUT values are much, much smaller? Is this proof of deliberate fraud by Rossi? Can we rely on the \u2018measurements\u2019 by the technician to know that?<\/p>\n
Rossi\u2019s response is that Investors measurements were done on a new high-temp model, with higher operating temperature, different power supply and hydrogen supply. Also, the method of input measurement is now different from the earlier method where there was lower input power. Thus, the Rossi September 9 report reflected the earlier testing of another E-Cat.<\/p>\n
Engineers working with\/for Rossi acknowledges that there are problems with measurement of input power. \u201cThe problem was solved (after the Swedish incident) through use of a VARIAC (variable voltage and current transformer) to stabilize the current and voltages,\u201d \u201cCures\u201d, the test engineer said.<\/p>\n
Apparently Rossi let his guard down by allowing this unknown \u2018technician\u2019 to wander around the shop and grab a quick (probably a clamp-on meter) INPUT reading on the Hot-Cat? Without knowing what is in that power supply, how could anyone measure and calculate accurate INPUT values? All of these measurements; Technician\u2019s and Rossi\u2019s are of little value \u2013 only INDEPENDENT, THIRD-PARTY VALIDATION TESTING can be relied on for confirmation that the E-Cat and Hot-Cat are real and are a new science and technology ready for commercial use.<\/p>\n
All we can do now is be patient and hope that Andrea Rossi can prevail and deliver his E-Cat technology for both domestic and industrial use. The world is counting on you Rossi. Be brave and be strong \u2013 don\u2019t let this crisis stop you.<\/p>\n","protected":false},"excerpt":{"rendered":"
Information from websites that monitor the development of the Rossi E-Cats (3 or 4 separate models) indicate that Rossi has sidelined the original \u201clow-temperature\u201d E-Cats in favor of developing the new 1200\u00b0C \u201cHot-Cat\u201d. This new reactor would be the \u201cHoly … Continue reading